| MATERIAL SAFETY
DATA SHEET |
| SECTION
1 - IDENTIFICATION |
| PRODUCT
NAME: Motion-Plus™ Anti-Friction
Grease |
EMERGENCY
TELEPHONE: (786) 336 0630 |
| TRADER
OWNER: M & J Sunshine Corporation |
INFORMATION
FAX: (305) 336 0629 |
TRADER
ADDRESS: 5220 NW 72nd Avenue #24
Miami, FL 33166 |
|
|
| SECTION
2 - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION |
| HAZARDOUS
COMPONENTS |
OSHA PEL |
ACGIH
TLV |
PERCENT |
CAS
NUMBER |
| Halogenated |
N.D. |
N.D. |
None |
108171-27-3 |
| Lithium 12 Hydroxystearate
Sebacate Complex |
None |
None |
8-12% |
68815-49-6 |
| Mineral Oil |
>3% 500 ppm
|
5 mg/m3 |
40-60% |
64742-65-0 |
| Mineral Oil |
>3% 500 ppm
|
5 mg/m3 |
25-45% |
64742-62-7 |
| Mineral Oil |
>3% 500 ppm
|
5 mg/m3 |
4-6% |
64742-52-5 |
| Zinc Oxide |
None |
None |
0-2% |
1314-13-2 |
|
| SECTION
3 - PHYSICAL/CHEMICAL CHARACTERISTICS |
BOILING
POINT: 500oF
VAPOR PRESSURE (mm Hg): NE
VAPOR DENSITY (air = 1): NE
SOLUBILITY IN WATER: Negligible
APPEARANCE AND ODOR: Smooth cream in color, bland
|
SPECIFIC
GRAVITY: 0.86 @ 16oC
MELTING POINT: 500oF
EVAPORATION RATE: NE
FREEZING POINT: -18oC (0oF)
NLGI NO.: All grades |
|
| SECTION
4 - FIRE AND EXPLOSION HAZARD DATA |
FLASH
POINT AND METHOD USED: 475oF D-92
FLAMMABLE LIMITS: Lower: Not Applicable Upper: Not Applicable
AUTOIGNITION TEMPERATURE: 600oF
|
EXTINGUISHING
MEDIA: CO2, dry chemical, earth and sand
SPECIAL FIRE FIGHTING PROCEDURES: Water may cause frothing
UNUSUAL FIRE AND EXPLOSION HAZARDS: Unknown
|
|
| SECTION
5 - REACTIVITY DATA |
STABILITY:
Stable under normal conditions.
INCOMPATIBILITY (materials to avoid): Strong Oxidizers.
HAZARDOUS DECOMPOSITION/BYPRODUCTS: Halogens, CO and CO2 if incomplete
combustion
|
HAZARDOUS
POLYMERIZATION: Will not occur
CONDITIONS TO AVOID: Open flames
|
|
| SECTION
6 - HEALTH HAZARD DATA |
| ROUTE(S) OF ENTRY:
Inhalation? No. Skin? Yes Ingestion? Yes |
| HEALTH HAZARDS-ACUTE
TOXICOLOGICAL PROPERTIES: Mild skin and eye irritant. |
| CARCINOGENICITY:
None - NTP? No IARC Monographs? No OSHA Regulated? No |
| SIGNS & SYMPTOMS
OF EXPOSURE: Mild irritation and reddening of eyes and sensitive skin |
| MEDICAL CONDITIONS
GENERALLY AGGRAVATED BY EXPOSURE: None |
|
EMERGENCY AND FIRST AID PROCEDURES:
Eyes: Immediately
flush with large quantities of water for at least 15 minutes
Skin Contact: Wash thoroughly with soap and water; remove and
launder contaminated clothing
Inhalation: Remove exposed person to fresh air if discomfort is
experienced while handling hot product.
Ingestion: Call a physician immediately. Do not induce vomiting.
|
|
ADVICE TO PHYSICIANS: High velocity injection under the skin may
result in serious injury. If left untreated the affected area is
subject to infection, disfigurement, lack of blood circulation and
may require amputation. When dispensed by high-pressure equipment,
this material can easily penetrate the skin and leave a bloodless
puncture wound. Material injected into a finger can be deposited
into the palm of the hand. Within 24-48 hours the patient may experience
swelling, discoloration and throbbing pain in the affected area.
Immediate treatment by a surgical specialist is recommended.
|
|
| SECTION
7 - CONTROL MEASURES |
| STEPS TO BE TAKEN
IN CASE MATERIAL IS RELEASED OR SPILLED: Absorb with sand or inert
material; sweep or scoop up and remove. |
| WASTE DISPOSAL
METHOD: Consult federal, state or local authorities for proper disposal
procedures. All disposals must comply with federal, state and local
regulations. |
| PRECAUTIONS FOR
HANDLING AND STORING: Keep away from sparks and open flames |
| OTHER PRECAUTIONS:
Wash thoroughly after handling with soap and water; do not get in
eyes or clothing. |
|
| SECTION
8 - PRECAUTIONS FOR SAFE HANDLING AND USE |
| RESPIRATORY
PROTECTIONS: None normally required |
| VENTILATION:
Use with adequate ventilation |
| PROTECTIVE
GLOVES: Neoprene, polyethylene, polyvinylchloride, butyl rubber, natural
rubber |
| EYE
PROTECTION: Face shield |
| OTHER
PROTECTIVE EQUIPMENT/CLOTHING: None normally required |
| WORK/HYGIENIC
PRACTICES: Wash thoroughly after handling, do not get in eyes or on
clothing; keep container closed; keep away from sparks and open flames;
good housekeeping conditions. |
|
| SECTION
9 - NFPA RATING |
| HEALTH: 0 |
FIRE: 1 |
REACTIVITY: 0
|
SPECIAL: 0 |
|
| SECTION
10 - TRANSPORTATION |
DOT ID
No.: N/A
DOT LABEL REQUIRED: None
FREIGHT CLASSIFICATION: Lubricating grease
HAZARD CLASS: Nonhazardous
PACKING GROUP: N/A
The information and recommendations contained herein are based upon data
believed to be correct. However, no guarantee or warranty of any kind, expressed
or implied, is made with respect to the information contained herein. This
Material Safety Data Sheet was prepared to comply with the OSHA Hazard Communication
Standard (29 CFR 1910.1200). This supersedes any previous information. |
