| MATERIAL SAFETY
DATA SHEET |
| SECTION
1 - IDENTIFICATION |
| PRODUCT
NAME: Motion-Plus Motorcycle Treatment |
EMERGENCY
TELEPHONE: (786) 336 0630 |
| TRADER
OWNER: M & J Sunshine Corporation |
INFORMATION
FAX: (786) 336 0629 |
TRADER
ADDRESS: 5220 NW 72nd Avenue #24
Miami, FL 33166 |
|
|
| SECTION
2 - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION |
| HAZARDOUS
COMPONENTS |
OSHA PEL |
ACGIH
TLV |
LIMITS RECOMMENDED |
CAS
NUMBER |
| Organic Petroleum Hydrocarbons |
> 3% 500 ppm |
5 mg/m3 |
None |
|
| The specific chemical identity is being withheld as a trade secret under Par. 317.2, PA Right to Know. This substance is not hazardous, but comprises of more than 3% of product. |
| Aliphatic Hydrocarbons |
>3% 500 ppm |
5 mg/m3 |
None |
64742-53-6 |
| Petroleum Naphtha |
>3% 500 ppm |
5 mg/m3 |
None |
64742-65-0 |
| This
product does not contain any chemical listed as a carcinogen or mutagen
by OSHA, IARC Monographs or the National Toxicology Program; does
not contain any ozone depleting substances or heavy metals and complies
with the RCRA Clean Air Act of 1991. |
|
| SECTION
3 - PHYSICAL/CHEMICAL CHARACTERISTICS |
BOILING
POINT: > 380oF
VAPOR PRESSURE (mm Hg):
1 @ 25oC
VAPOR DENSITY (air = 1): N/A
SOLUBILITY IN WATER:
Insoluble
|
SPECIFIC
GRAVITY: 1.06
MELTING POINT: N/A
EVAPORATION RATE:
0.01
APPEARANCE AND ODOR: Light amber, low viscosity liquid, aromatic petroleum odor |
|
| SECTION
4 - FIRE AND EXPLOSION HAZARD DATA |
FLASH
POINT AND METHOD USED:
230oFPMCC
FLAMMABLE LIMITS:
N/A
EXTINGUISHING MEDIA:
Foam, waterfog, chemical, CO
|
SPECIAL
FIRE FIGHTING PROCEDURES: Pressure-demand, self-contained breathing apparatus should be provided for firefighters in confined areas where stored.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Product is nonexplosive and not combustible under normal conditions. It flows freely when hot and should be treated as an oil when exposed in a fire
|
|
| SECTION
5 - REACTIVITY DATA |
STABILITY:
Stable under normal conditions
CONDITIONS TO AVOID:
Open flames and extremely high temperatures (molten)
INCOMPATIBILITY (materials to avoid): Strong oxidizers
|
HAZARDOUS
DECOMPOSITION/BYPRODUCTS: Carbon dioxide, carbon monoxide, halogenated hydrocarbons and other hydrocarbons if combustion is not complete
HAZARDOUS POLYMERIZATION: Will not occur
CONDITIONS TO AVOID: None known
|
|
| SECTION
6 - HEALTH HAZARD DATA |
| ROUTE(S) OF ENTRY:
Inhalation? Yes Skin? Limited Ingestion?
Possible
(deliberate) |
| HEALTH HAZARDS-ACUTE
TOXICOLOGICAL PROPERTIES: Under normal use conditions, not expected to produce toxicity via inhalation or skin. Ingestion of product may produce nausea and vomiting, but no long-term effects. |
| CARCINOGENICITY:
None NTP? No IARC Monographs? No OSHA Regulated? No |
| SIGNS & SYMPTOMS
OF EXPOSURE:
Mild irritation of eyes; the toxicity profile shows excessive inhalation of vapors can cause nasal and respiratory irritation, dizziness, fatigue, headaches and nausea
|
| MEDICAL CONDITIONS
GENERALLY AGGRAVATED BY EXPOSURE:
None determined
|
| EMERGENCY
& FIRST AID PROCEDURES:
Eyes: Immediately flush with large quantities of water for at least
15 minutes and call a physician if irritation
persists.
Skin: Wash thoroughly with soap and water.
Inhalation: Remove exposed person to fresh air and ventilate area.
Ingestion: Call a physician. Do NOT induce vomiting. Never give
anything by mouth to an unconscious person. |
|
| SECTION
7 - CONTROL MEASURES |
| STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: If material is spilled or released to the atmosphere, steps should be taken to contain liquids and prevent discharges to streams or sewer systems and control to stop loss of volatile materials to the atmosphere. Spills or releases should be reported to appropriate agencies. |
| WASTE DISPOSAL METHOD: Dispose of absorbent in accordance with all applicable Federal, State and Local regulations. |
| PPRECAUTIONS FOR HANDLING AND STORING: Keep container closed until ready for use. Keep away from feed and food products. Store away from ignition sources. Do not use welder or cutting torch on or near container |
| OTHER PRECAUTIONS:
Do
not store in temperatures above 130oF.Remove and launder contaminated clothing.
|
|
| SECTION
8 - PRECAUTIONS FOR SAFE HANDLING AND USE |
| RESPIRATORY
PROTECTIONS:
If TLV is exceeded, use NIOSH/OSHA-approved respirator with organic filter
|
VENTILATION:
Local exhaust -
not normally required
Mechanical (general) - not required
Special - none
Other adequate ventilation - None |
| PROTECTIVE
GLOVES: Neoprene or Buna-N |
| EYE
PROTECTION: Chemical safety goggles and, if handled hot, full face shield |
| OTHER
PROTECTIVE EQUIPMENT/CLOTHING: None |
| WORK/HYGIENIC
PRACTICES: Use usual, good hygienic practices; wash thoroughly after
use. |
|
| SECTION
9 - NFPA RATING |
| HEALTH: 2 |
FIRE: 1 |
REACTIVITY: 0
|
SPECIAL: 0 |
|
| SECTION
10 - TRANSPORTATION |
DOT ID No.: N/A DOT LABEL REQUIRED: None
FREIGHT CLASSIFICATION: Lubricating oil
HAZARD CLASS: Nonhazardous
PACKING GROUP: N/A
The
information and recommendations contained herein are based upon data believed
to be correct. However, no guarantee or warranty of any kind, expressed
or implied, is made with respect to the information contained herein.
This Material Safety Data Sheet was prepared to comply with the OSHA Hazard
Communication Standard (29 CFR 1910.1200). This supersedes any previous
information. |
