| MATERIAL SAFETY
DATA SHEET |
| SECTION
1 - IDENTIFICATION |
| PRODUCT
NAME: Motion-Plus™ Engine Treatment
|
EMERGENCY
TELEPHONE: (786) 336 0630 |
| TRADER
OWNER: M & J Sunshine Corporation |
INFORMATION
FAX: (786) 336 0629 |
TRADER
ADDRESS: 5220 NW 72nd Avenue #24
Miami, FL 33166 |
|
|
| SECTION
2 - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION |
| HAZARDOUS
COMPONENTS |
OSHA PEL |
ACGIH
TLV |
LIMITS RECOMMENDED |
CAS
NUMBER |
| Organic Petroleum
Hydrocarbons |
>3% 500 ppm |
5 mg/m3 |
None |
|
| The
specific chemical identity is being withheld as a trade secret under
Par. 317.2, PA Right to Know. This substance is not hazardous, but
comprises of more than 3% of product. |
| Aliphatic Hydrocarbons |
>3% 500 ppm |
5 mg/m3 |
None |
64742-53-6 |
| Petroleum Lube
Oil |
>3% 500 ppm
|
5 mg/m3 |
None |
64742-65-0 |
| This
product does not contain any chemical listed as a carcinogen or mutagen
by OSHA, IARC Monographs or the National Toxicology Program; does
not contain any ozone depleting substances or heavy metals and complies
with the RCRA Clean Air Act of 1991. |
|
| SECTION
3 - PHYSICAL/CHEMICAL CHARACTERISTICS |
BOILING
POINT: > 380oF
VAPOR PRESSURE (mm Hg): < 1 @ 25oC
VAPOR DENSITY (air = 1): N/A
SOLUBILITY IN WATER: Insoluble
|
SPECIFIC
GRAVITY: 1.06
MELTING POINT: N/A
EVAPORATION RATE: < 0.01
APPEARANCE AND ODOR: Light amber, low viscosity liquid, aromatic petroleum
odor |
|
| SECTION
4 - FIRE AND EXPLOSION HAZARD DATA |
FLASH
POINT AND METHOD USED: >230oF PMCC
FLAMMABLE LIMITS: N/A
EXTINGUISHING MEDIA: Foam, waterfog, chemical, CO2
|
SPECIAL
FIRE FIGHTING PROCEDURES: Pressure-demand, self-contained breathing
apparatus should be
provided for firefighters in confined areas where stored.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Product is nonexplosive and not
combustible under normal
conditions. It flows freely when hot and should be treated as an oil
when exposed in a fire
|
|
| SECTION
5 - REACTIVITY DATA |
STABILITY:
Stable under normal conditions
CONDITIONS TO AVOID: Open flames and extremely high temperatures (molten)
INCOMPATIBILITY (materials to avoid): Strong oxidizers
|
HAZARDOUS
DECOMPOSITION/BYPRODUCTS: Carbon dioxide, carbon monoxide, halogenated
hydrocarbons and other hydrocarbons if combustion is not complete
HAZARDOUS POLYMERIZATION: Will not occur
CONDITIONS TO AVOID: None known
|
|
| SECTION
6 - HEALTH HAZARD DATA |
| ROUTE(S) OF ENTRY:
Inhalation? No. Skin? No
Ingestion?
Possible (deliberate) |
HEALTH HAZARDS-ACUTE
TOXICOLOGICAL PROPERTIES: Under normal use conditions, not expected
to
produce toxicity via inhalation or skin. Ingestion of product may
produce nausea and vomiting, but no long-term effects. |
| CARCINOGENICITY:
None NTP? No IARC
Monographs? No OSHA
Regulated? No |
| SIGNS & SYMPTOMS
OF EXPOSURE: Mild irritation of eyes; the toxicity profile shows excessive
inhalation of vapors can cause nasal and respiratory irritation, dizziness,
fatigue, headaches and nausea |
| MEDICAL CONDITIONS
GENERALLY AGGRAVATED BY EXPOSURE: None determined |
| EMERGENCY
& FIRST AID PROCEDURES:
Eyes:
Immediately flush with large quantities of water for at least
15 minutes and call a physician if irritation
persists.
Skin: Wash thoroughly with soap and water.
Inhalation of combusted fumes: Remove exposed person to
fresh air.
Ingestion: Call a physician. Do NOT induce vomiting. Never
give anything by mouth to an unconscious person.
|
|
| SECTION
7 - CONTROL MEASURES |
| STEPS TO BE TAKEN
IN CASE MATERIAL IS RELEASED OR SPILLED: If material is spilled or
released to the atmosphere, steps should be taken to contain liquids
and prevent discharges to streams or sewer systems and control to
stop loss of volatile materials to the atmosphere. Spills or releases
should be reported to appropriate agencies. |
| WASTE DISPOSAL
METHOD: Dispose of absorbent in accordance with all applicable Federal,
State and Local regulations. |
PRECAUTIONS FOR
HANDLING AND STORING: Keep container closed until ready for use. Keep
away from feed
and food products. Store away from ignition sources. Do not use welder
or cutting torch on or near container |
| OTHER PRECAUTIONS:
Do not store in temperatures above 130oF. Remove and launder contaminated
clothing. |
|
| SECTION
8 - PRECAUTIONS FOR SAFE HANDLING AND USE |
| RESPIRATORY
PROTECTIONS: If TLV is exceeded, use NIOSH/OSHA-approved respirator
with organic filter |
VENTILATION:
Local exhaust - not normally required
Mechanical (general) - not required
Special - none
Other adequate ventilation - none |
| PROTECTIVE
GLOVES: Neoprene or Buna-N |
| EYE
PROTECTION: Chemical safety goggles and, if handled hot, full face
shield |
| OTHER
PROTECTIVE EQUIPMENT/CLOTHING: None |
| WORK/HYGIENIC
PRACTICES: Use usual, good hygienic practices; wash thoroughly after
use. |
|
| SECTION
9 - NFPA RATING |
| HEALTH: 0 |
FIRE: 1 |
REACTIVITY: 0
|
SPECIAL: 0 |
|
| SECTION
10 - TRANSPORTATION |
DOT ID
No.: N/A
DOT LABEL REQUIRED: None
FREIGHT CLASSIFICATION: Lubricating oil
HAZARD CLASS: Nonhazardous
PACKING GROUP: N/A
The information and recommendations contained herein are based upon data
believed to be correct. However, no guarantee or warranty of any kind, expressed
or implied, is made with respect to the information contained herein. This
Material Safety Data Sheet was prepared to comply with the OSHA Hazard Communication
Standard (29 CFR 1910.1200). This supersedes any previous information.
|
